Remove the valve from the main board by unplugging it from the board and manifold. If it is determined the device is out of tolerance, replace Main Board. Server Safety Information To reduce the risk of bodily injury, electrical shock, fire, and equipment damage, read this document and observe all warnings and precautions in this guide before installing More information. Before using any camera or video. SpO 2 Disassembly – General Step 3:

Uploader: Felabar
Date Added: 25 May 2016
File Size: 49.51 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 41418
Price: Free* [*Free Regsitration Required]

Wipe away excess solution, and clean the product again with a cloth dampened in distilled water. Center pump over the outline on the board and secure it with tie wraps. If the touch panel calibration is successful, a second window will open.

IQvitals and IQvitals PC – PDF

qivitals Midmark with IQscale TM feature not enabled device is configured to communicate with Fairbanks scale instead. See section B of this Service Manual. D-3 Removing the Main Board Reconnect the power cable, touch panel cable, and backlight cable.


Display Changes to Numerical Value B Important Safety Instructions B. A periodic functional check is warranted.

IQvitals Supplies by Midmark

See Section B of this Service Manual. Comfortable Behind the Neck design More information. Do not over tighten screws, but make sure that the brackets do not move after installation. Touchscreen out of calibration or not working. Ensure that readings are within specifications. Reassembly – Iavitals the Main Board Step 3: Battery Life shorter than usual.

Iqvitals Zone Wireless USB Dongle by Midmark

Lenovo Miix 2 8. Be sure to press tie wraps against the bottom of the main board while tightening them. The SpO 2 circuitry contains a calibration potentiometer that is set at the factory.

A all four screws B the battery C the battery door two screws D Caution Substitution of components different from those supplied could result in measurement error. Check weight at 50,and lbs.

Confirm that the battery charging light on the front of the device is blinking charging. YOU are responsible for the safe operation of this equipment.


Secure the new board with the bracket and screws. Plug the valve into the connector.

Midmark – McKesson Medical-Surgical

If problem persists, check for damaged connector on I-O Board. Plug the pump into the connector.

Test with a known-working cuff. Device immediately powers off when disconnected from mains. Remove the detergent from the product using a cloth dampened in distilled water. Cut and iqvitalss the two tie wraps that hold the NIBP pump.

Patient s pulse signal has persistent variability due to arrhythmia or valvular problem. Manual Inflation Blood Pressure Monitor. Peel off the Kapton tape that secures the speaker and temperature cables.

Start the discussion

Leave a Reply

Your email address will not be published. Required fields are marked *